Remote ID

VERSION

Contact Us

    Holybro RemoteID Module is a low-cost, small-size, and light-weight module that broadcasts information about UAVs in flight through WiFi and Bluetooth. It supports both CAN and serial protocols. It is a FCC and CE-approved radio module.

    The products run open-source firmware (ArduRemoteID) and provides a so-called standard Remote ID solution, primarily target drone manufacturers & system integrators.

    If you need customization or have special request, feel free to reach out to us via email.

     
    Specification
    • Radio module:
      • Espressif ESP-C3 module
      • Bluetooth and WiFi 2.4GHz (ERP): + 20 dBm (100 mW)
      • FCC & CE certified radio module
    • Firmware:
      • ArduRemoteID (https://github.com/ArduPilot/ArduRemoteID).
      • Supports upgrading firmware via the web interface (“OTA”)
    • Supported in PX4 & Ardupilot (More Info)
    • Protocol: CAN & Serial
    • Interface:
      • 1x JST GH 4-pin CAN (CAN) port
      • 1x JST GH 6-pin TELEM (UART) port
    • Antenna Connector type:
      • On CNC Case: SMA connector
      • On PCB: IPEX Connector
    • Range: > 5km detection range*
    • Power: 5V supplied from TELEM or CAN port
    • LED lights: Bright RGB status LED
    • Size:
      • Without case: 35.3 x 23.5 mm (not including antenna)
      • With CNC case: 38 x 26.5 x 11.5 mm (not including antenna)
    • Mount: M2 screws
    • Operating temperature: -40°C to +85°C
    • Weight:
      • PCB only: 4 g
      • With CNC case & Antenna: 27.5g
      • Without case & Antenna: 16.5g (Cable 20cm)
    • Certification: FCC & CE
    Guides & Reference Link
    • Holybro Doc
      • Setup & Configuration Guide
      • Firmware Update Guide
      • Firmware support
    • Ardupilot
      • Ardupilot Wiki – RemoteID
      • Ardupilot Wiki – OpenDroneID FW building
    • PX4
      • PX4 Guide on Remote ID/OpenDroneID
     
    Package Includes：
    • 1x Remote ID
    • 1x Antenna
    • 1x JST GH 6pin 150mm Cable
    • 1x JST GH 4pin 150mm Cable