Customize Consent Preferences

We use cookies to help you navigate efficiently and perform certain functions. You will find detailed information about all cookies under each consent category below.

The cookies that are categorized as "Necessary" are stored on your browser as they are essential for enabling the basic functionalities of the site. ... 

Always Active

Necessary cookies are required to enable the basic features of this site, such as providing secure log-in or adjusting your consent preferences. These cookies do not store any personally identifiable data.

No cookies to display.

Functional cookies help perform certain functionalities like sharing the content of the website on social media platforms, collecting feedback, and other third-party features.

No cookies to display.

Analytical cookies are used to understand how visitors interact with the website. These cookies help provide information on metrics such as the number of visitors, bounce rate, traffic source, etc.

No cookies to display.

Performance cookies are used to understand and analyze the key performance indexes of the website which helps in delivering a better user experience for the visitors.

No cookies to display.

Advertisement cookies are used to provide visitors with customized advertisements based on the pages you visited previously and to analyze the effectiveness of the ad campaigns.

No cookies to display.

PM07 Power Module (14S)

Contact Us

    This PM07 Power Module supplies clean 5.2V to flight controller from the battery and provides current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable, along with integrated esc power & signal distribution for up to 8 ESCs.

    PM07 has two 5.2V power output port that can provide redundant power to the flight controller, with independent circuits, BEC IC and circuitry.

    It is also great for flight controller that do not have built-in servo header pins like the Pixhawk 6C & Pixhawk 4. It comes with pre-soldered wires, capacitor, and XT60 connector. 

    Specifications
    • Input voltage: 2S-14S
    • PCB Cont. Current Rating: 90A
    • PCB Burst Current Rating: 140A (<60 Sec)
    • Output: DC 5.2V & 3A Max 
    • Voltage Divider: 18.182
    • Amperes per Volt: 36.364

    Please Note: 
    1. The XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60A burst current (< 60 Seconds). If a higher current is being used, the plug type and wire size should be changed accordingly. You can refer to this chart for reference. 
    2. This PM07 Power Module uses analog data output and is not compatible to the Pixhawk 5X & 6X (Requires a digital PM like PM02D). 
    Mechanical Specification:
    • Dimensions:68*50*10 mm
    • Mounting Holes:45*45mm
    • Weight: 43.8g

     

    Package Includes
    • 1x   PM07 board
    • 1x   80mm XT60 connector wire (installed)
    • 1x   Electrolytic capacito: 220uF 63V (installed)
    • 2x   JST GH 10P Cable
    • 1x   JST GH 8P Cable
    • 2x   JST GH 6P Cable