PM06 V2 Power Module

Option

Contact Us

    This PM06 Power Module supplies clean 5.2V to flight controller from the battery and provides current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable, along with integrated power distribution for 4 ESCs. It comes with pre-soldered wires, capacitor, and XT60 connector.

    Specifications
    • Input voltage (10S version): 2S-10S
    • Input voltage (14S version): 2S-14S
    • PCB Cont. Current Rating: 70A
    • PCB Burst Current Rating: 120A (<60 Sec)
    • Output: DC 5.2V & 3A Max 
    • Ouput Max Power : 18W
    • Voltage Divider: 18.182
    • Amperes per Volt: 36.364 
    Please Note: 
    • The XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60A burst current (< 60 Seconds). If a higher current is being used, the plug type and wire size should be changed accordingly. You can refer tothis chartfor reference.
    • This PM02 Power Module uses analog data output and is not compatible to the Pixhawk 5X & 6X (Requires a digital PM like PM02D). 
    Mechanical Specification:
    • Dimensions: 35x35x5mm
    • Mounting hole: 30.5mm*30.5mm
    • Weight: 24g

     

    Package Includes
    • 1x  PM06 Power Module
      1x  JST GHR 6pin 1.25mm pitch cable
    Pin Map:

    Setup guide for PX4 & Ardupilot can be found in the Holybro Doc here.